Welcome, Guest
Username: Password: Remember me

TOPIC: Unable to Adjust Material Issue quantity to 0

Unable to Adjust Material Issue quantity to 0 #3023

  • Bob
  • Bob's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 2
  • Karma: 0
In Macola ES v9.6.200 under POP>Process>Adjust Material Issue we are trying to adjust the quantity on a line to 0. We can change the quantity to 0 and Save, but when we re-open the production order, it still has the original quantity. We can't delete the line either, as the Delete button is greyed out.

Any ideas?

Thanks!
Bob
The administrator has disabled public write access.

Unable to Adjust Material Issue quantity to 0 #3035

  • valvemfg
  • valvemfg's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 10
  • Thank you received: 3
  • Karma: 1
You might try to "Unrelease" the POP order. That should put your material back on inventory. But you will only be able to unrelease the order if you haven't reported production against it. If you have reported production then you wouldn't want to adjust the material to zero, but to the amount actually used. Hope that helps. :)
The administrator has disabled public write access.
The following user(s) said Thank You: Bob

Unable to Adjust Material Issue quantity to 0 #3036

  • Bob
  • Bob's Avatar
  • OFFLINE
  • Fresh Boarder
  • Posts: 2
  • Karma: 0
Thank you -- that's very helpful! We were able to unrelease the order and then delete the item. Unfortunately we then have to go through the painstaking process of re-entering bin #'s for numerous items again when re-releasing it, but we can deal with that.
Much appreciated!
Bob
The administrator has disabled public write access.
Time to create page: 0.029 seconds
Powered by Kunena Forum  Protected by R Antispam